I have setup a 2 channel mixer and A and B bins. A bin uses Layer A and B bin uses Layer B. I'm trying to do an automated run thru the clips by using the Out points of the clip. So when an A clip reaches an arbitrary point before the A Out point, say 1 second, the B clip is started, the mixer is triggered to transition to the B clip and the A bin moves 2 clips over. Then the process is repeated using the B side. I have this working, sort of, using the end of the clips. But I can't figure out how to do this with the Out point. I am also seeing a white blip on the screen at the transition process. I am an EXTREME newbie so excuse me if I am asking a question that is easily addressed. I would greatly appreciate any help with this.
Thanks,
Joe B