Hello folks,
great work on the new software guys. I do have a question in regards to MIDI
triggering.
• I set up a two bus mixer similar to grid - alt preset.
• I then set my A bus to trigger clips on midi channel 1 notes.
• I then set my B bus to trigger clips on midi channel 2 notes.
The clips trigger correctly on either bus. But, sometimes both busses will trigger new clips. Even though they are being triggered by different midi channels.
If my midi controller is set to midi channel 1, then only Bus A should trigger. Not both at the same time.
Macbook Pro
Oxygen 8 controller